Stepping Up to Laser Processing for Flex, Part 2: Calculating and Optimizing Production
April 14, 2016 | Mike Jennings and Patrick Riechel, ESIEstimated reading time: 1 minute
A Process of Continual Improvement
In Part 1 of this series, we discussed the advantages of adding flex laser processing to gain a competitive advantage. In Part 2 we will build on that discussion, looking at the ways you can optimize your flexible circuit laser processing to get the efficiencies that drive lower cost of ownership. When considering the cost associated with adding FPC processing, where do you look, what should you expect, and how can you control or minimize those costs?
Controlling Fixed costs
Aside from the obvious system purchase price and its associated depreciation expense, there are a variety of other—and less significant—fixed costs to consider. These can include system installation and personnel training costs, costs to qualify the system prior to running production, floor space allocation overhead allocation costs, as well as the costs related to upgrading facilities to meet the system’s site requirements. We will discuss site preparation in Part 3.
Typical areas to watch for in laser system site requirements include electrical, vacuum, compressed air, environmental air, as well as temperature and humidity. Neglecting any of these can result in poor product yield, scrap, or even damage to and downtime on your valuable UV laser system. Poor electrical power quality and sporadic brownouts and blackouts often can result in unexpected system errors, yield issues, and scrap.
Extending System Longevity
Typical high-power UV lasers used for flex processing have lifespans ranging from 1–2 years, although those lifespans may be drawn out if the laser is not in 24/7 use or the laser powers used for processing are much lower than the system’s work surface laser power specification.
Editor's Note: This article originally appeared in the March 2016 issue of The PCB Magazine.
Suggested Items
Lockheed Martin Australia, The Department Of Defence Sign Strategic Partnership Head Contract
04/26/2024 | Lockheed MartinLockheed Martin Australia signed a landmark AUD$500 million contract with the Department of Defence to build Australia’s future Joint Air Battle Management System under project - AIR6500 Phase 1 (AIR6500-1).
Cadence, TSMC Collaborate on Wide-Ranging Innovations to Transform System and Semiconductor Design
04/25/2024 | Cadence Design SystemsCadence Design Systems, Inc. and TSMC have extended their longstanding collaboration by announcing a broad range of innovative technology advancements to accelerate design, including developments ranging from 3D-IC and advanced process nodes to design IP and photonics.
Siemens’ Breakthrough Veloce CS Transforms Emulation and Prototyping with Three Novel Products
04/24/2024 | Siemens Digital Industries SoftwareSiemens Digital Industries Software launched the Veloce™ CS hardware-assisted verification and validation system. In a first for the EDA (Electronic Design Automation) industry, Veloce CS incorporates hardware emulation, enterprise prototyping and software prototyping and is built on two highly advanced integrated circuits (ICs) – Siemens’ new, purpose-built Crystal accelerator chip for emulation and the AMD Versal™ Premium VP1902 FPGA adaptive SoC (System-on-a-chip) for enterprise and software prototyping.
Taiyo Circuit Automation Installs New DP3500 into Fuba Printed Circuits, Tunisia
04/25/2024 | Taiyo Circuit AutomationTaiyo Circuit Automation is proud to be partnered with Fuba Printed Circuits, Tunisia part of the OneTech Group of companies, a leading printed circuit board manufacturer based out of Bizerte, Tunisia, on their first installation of Taiyo Circuit Automation DP3500 coater.
Vicor Power Orders Hentec Industries/RPS Automation Pulsar Solderability Testing System
04/24/2024 | Hentec Industries/RPS AutomationHentec Industries/RPS Automation, a leading manufacturer of selective soldering, lead tinning and solderability test equipment, is pleased to announce that Vicor Power has finalized the purchase of a Pulsar solderability testing system.