Printed Electronics in Perspective
August 27, 2014 | Joe Fjelstad, Verdant ElectronicsEstimated reading time: 1 minute
Printed electronics have garnered a significant amount of press coverage over the last several years. What appears to have precipitated the explosion of interest in the middle of the last decade was a report that suggested that printed electronics would dominate electronic production by the mid-2020s with an annual market of over $300 billion. $300 billion is a big number and it not surprisingly captured a lot of attention. Since that announcement there has been a significant paring down of the market expectations to a number closer to one quarter the one projected earlier. It is, one can perhaps safely assume, an acknowledgement of the persistence of incumbent technologies. It seems clear to many knowledgeable observers that the potential of printed electronics was much more modest than early projections, but as Yogi Berra observed and has been often quoted, “Predictions are hard to make, especially about the future.”
The hyperbole surrounding the reports released in 2007 was met with some bemusement by those such as this writer, who having been first been involved in what would be called direct write printed electronics startup (using today’s broader definition) in 1990 had a different perception of the technology’s “newness.” Moreover, as one seeking to give credit where credit is due, it should be evident (if one puts in a bit of effort and does a little digging) that printed electronics is a technology that is arguably more than six decades old, thus predating my earlier company’s efforts by some 35 years.
The very first printed electronic circuits were called printed circuits because they were exactly that…printed, using conductive and resistive inks. Moreover, Xerox’s technology (then called the Haloid-Xerox Company) was applied to printing etch-resistant films for circuit production in the mid-1950s and more than 45 years ago, there was demonstration of a printed transistor in roll-to-roll fashion by Westinghouse.
Read the full article here.
Editor's Note: This article originally appeared in the August 2014 issue of SMT Magazine.
Suggested Items
iNEMI Webinar: Humidity Robustness and Insulation Coordination for e-Mobility
03/27/2024 | iNEMIThis webinar is a follow-up to the recent Seminar on Humidity Robustness and Insulation Coordination for e-Mobility, organized by iNEMI and ZESTRON Europe and supported by the ECPE.
Electronics Industry Sentiment Rises in March
03/27/2024 | IPCIPC releases March 2024 Global Sentiment of the Electronics Supply Chain Report
Mycronic to Showcase More Versatile, High-productivity Assembly Solutions at IPC APEX EXPO 2024
03/27/2024 | MycronicMycronic, the leading Sweden-based electronics assembly solutions provider, will continue to respond to growing customer demand for high-flexibility, high-productivity solutions for zero-defect PCB assembly at IPC APEX EXPO 2024 in Anaheim, CA on April 9 - 11.
Don Dennison Appointed to Roll Out KIC’s Latest Thermal Analysis System Software in the Northeast
03/26/2024 | KICKIC, a renowned pioneer in thermal process and temperature measurement solutions for electronics manufacturing, is pleased to announce the appointment of PIT Equipment Services, LLC, led by Don Dennison, as its representative for New York, New Jersey, and Eastern Pennsylvania.
The Many Complexities of PFAS
03/26/2024 | Marcy LaRont, PCB007 MagazineIn its simplest definition, PFAS is a group of chemicals used to make fluoropolymer coatings and products that resist heat, oil, stains, grease, and water. Fluoropolymer coatings can be in a variety of products. Though this definition is not inaccurate, it can be misleading. Depending on who you ask, there are upward of 10,000 PFAS chemistries that can meet various definitions.