Reading time ( words)
From the show floor at productronica 2017, we stopped by the DIS booth for a conversation with Tony Faraci. Here, he explains how DIS has tackled the challenges of handling and alignment of flex-rigid multilayer builds (especially cut-out pre-preg layers and packing pieces) and automated what was previously an operator-dependent manual process.
Watch The Interview Here:
Click here for more coverage from productronica 2017.
Nolan Johnson, I-Connect007
This issue is a special one. We devote the entire magazine to a detailed look at Green-Source Fabrication (a division of Whelen Engineering) and its brand new, fully automated HDI facility in New Hampshire. GreenSource is arguably the most advanced and automated fabrication facility in North America today.
In Part 1 of this column, I discussed the foundation of CIM and the principles of automation planning. In Part 2, we will assume that all the necessary preparations in strategy and tactics have been completed. How does it all fit together for successful implementation? This problem affects large, wealthy companies as well as the smallest job shop.
Patty Goldman, I-Connect007
When gathering info for this month’s topic on handling strategies, I knew there was much happening in the automation end of things and all that it can do for handling. But I also knew it was not something that is easy for the “little guy” to do—automation is expensive, in general, and it is not always conducive to the high mix of small lot sizes typical of the many prototypeplus facilities in North America and Europe.